Dometic B59516 Air Conditioner Instruction Manual
Dometic B59516 Air Conditioner
Dometic B59516 Air Conditioner Instructions
Here we offer the Dometic B59516 Air Conditioner manual completely free and in English. We have cataloged this manual in the Air Conditioners section on Manualverse, and it has been rated by 1 users with an average rating of 5. If you have any specific questions about Dometic B59516 Air Conditioner, we suggest checking the Frequently Asked Questions (FAQs) section of this manual.
Product Images
Dometic B59516 Air Conditioner Specifications
| Feature | Specification |
|---|---|
| Model Variant | B59516.71X |
| Product Type | Roof-mounted RV air conditioner |
| Nominal Cooling Capacity | 15,000 BTU/hr |
| Electrical Rating | 120 Vac, 60 Hz, single phase |
| Compressor Rated Load Amps | 13.3 A |
| Compressor Locked Rotor Amps | 70.0 A |
| Fan Motor Rated Load Amps | 2.0 A |
| Fan Motor Locked Rotor Amps | 5.6 A |
| Refrigerant | R-410A, 18.3 oz |
| Minimum Wire Size | 12 AWG copper, up to 24 ft (longer runs per NEC) |
| AC Circuit Protection | 20 A time delay fuse or circuit breaker (installer supplied) |
| Minimum Generator Size | 3.5 kW (1 unit) / 5.0 kW (2 units) |
| Compatible Air Distribution Box | 3314851.000 |
| Control Type | Integral mechanical |
| Nominal Unit Dimensions (FIG. 2) | 12-7/8″ height, 27-5/8″ and 29-5/8″ footprint dimensions |
| Required Roof Opening | 14-1/4″ x 14-1/4″ (±1/8″) |
| Roof Framing Requirement | Rafters/joists on minimum 16″ centers |
| Roof-to-Ceiling Distance | 1.5″ minimum to 6″ maximum |
| Ceiling Thickness Range (Duct Divider) | 1.5″ to 6.5″ |
| Roof Load Requirement | 130 lb in motion (typically met by 200 lb static load design) |
| Maximum Roof Tilt | 15° (all directions) |
| Nominal ADB Dimensions | 23-1/8″ x 21-1/8″ |
| Mounting Bolt Pattern | 4 bolts, locations A, D, E and H |
| Mounting Bolt Torque | 40 to 50 in-lb, tightened evenly |
| Duct Divider Position | 5-5/8″ from back of roof opening |
| Framing Stock Thickness | 3/4″ minimum |
| Supply Wire Extension into Opening | 15″ minimum |
| Thermostat Range | Approx. 65 °F to 90 °F (measured at ADB inlet) |
| Selector Switch | 8 positions including OFF |
| Fan Speeds | High, Medium, Low |
| Compressor Restart Delay | 2 minutes minimum |
| Filter Cleaning Interval | At least every 2 weeks of operation |
| Applicable Codes | ANSI/NFPA 70, ANSI/NFPA 1192, CSA C22.1, CSA Z240 RV Series |
| Manual Form Number | 3315079.016, Revision D (01/18) |
Dometic B59516 Air Conditioner Details
The Dometic B59516 is a rooftop air conditioner built for recreational vehicles. It can go on during RV manufacture or be added later. One person can install it with brief help from others, but the manual says a qualified service technician must install and service it. Dometic forbids modifying the unit or adding accessories it has not authorized in writing, because unauthorized changes can be extremely dangerous.
The unit is normally placed over an existing roof vent opening. With no vent, a single unit goes slightly forward of center (front to back) and centered side to side. A two-unit setup places one unit one third and the other two thirds of the way back from the front of the RV. When choosing capacity, consider RV size, window area, insulation, geographic location and the comfort level you want.
Before cutting the roof, the installer must shut off the gas supply, disconnect 120 Vac power and disconnect the positive 12 Vdc battery terminal. The opening must sit between roof reinforcing members and must never create a low spot where water could pool. The ceiling opening is framed so air is not drawn from the roof cavity, and an entry hole for the power supply is left at the front.
The unit must be lifted onto the roof and set over the opening. It must never be slid, because sliding can damage the bottom gasket and cause leaks. From inside the RV, the installer cuts the duct divider to match the ceiling thickness, with the foil back facing the rear. A polarized 6-pin cord from the rooftop unit plugs into the matching connector in the electronic control box, so it can only be connected one way.
The power supply is wired white to white and black to black, with the bare copper ground fastened under the grounding screw in the junction box. The connectors are taped so they cannot vibrate loose on the road. The air distribution box is fastened with two sheet metal screws and eight wood screws. The front and rear vent doors are installed afterwards, followed by the filter, the snap-in return air grille and the control knobs.
In cooling mode, High Cool gives maximum cooling and dehumidification, Medium Cool handles normal needs and Low Cool maintains comfort and is suited to nighttime use. The fan keeps running while the compressor cycles off, which keeps temperatures even throughout the RV. A sliding lever opens and closes the center air discharge.
With the optional electric heater installed, the OPT HEAT setting removes the chill on cool mornings. It does not replace a furnace, and the thermostat does not cycle the heater. Maintenance is simple: wash the filter with soap and warm water, and clean the housing with a mild detergent. Never use polish or scouring powders. The blower motor is factory lubricated and needs no service.
The manual also covers frost on the coil, heat gain and condensation. Ways to reduce heat gain include parking in shade, using blinds, keeping doors shut, avoiding heat-producing appliances and starting the unit early in the day. Before calling for service, check the generator output, the land-line sizing and the breaker. The model and serial label is on the unit's base pan, visible once the return grille is removed.
Frequently Asked Questions (FAQs)
Can't find the answer you need? Here are some frequently asked questions about the Dometic B59516 Air Conditioner, and we answer them below.
