Drayton Digistat 1RF Thermostat Instruction Manual
Drayton Digistat 1RF Thermostat
Drayton Digistat 1RF Thermostat
Drayton Digistat 1RF Instructions
Here we offer the Drayton Digistat 1RF Thermostat manual completely free and in English. We have cataloged this manual in the Thermostats section on Manualverse, and it has been rated by 1 users with an average rating of 5. If you have any specific questions about Drayton Digistat 1RF Thermostat, we suggest checking the Frequently Asked Questions (FAQs) section of this manual.
Product Images
Drayton Digistat 1RF Thermostat Specifications
| Feature | Specification |
|---|---|
| Manufacturer | Drayton (Schneider Electric Controls UK Ltd) |
| Product Type | Wireless digital room thermostat with SCR receiver |
| Part Numbers | RF710N (Digistat+1RF thermostat and SCR kit), 22190N (spare thermostat), 22149 (spare SCR) |
| Thermostat Power Supply | 2 x 1.5V IEC LR6 (AA) alkaline batteries |
| Battery Life | 2 years typical |
| SCR Receiver Power Supply | 230V a.c. 50Hz, fused at 3A |
| SCR Switch Type and Rating | SPDT (voltage free) 2(1)A 230V a.c. or 24V a.c./d.c. |
| SCR Terminals | N, L, 1 (Common), 2 (Heating satisfied or call for cooling), 3 (Call for heat) |
| Radio Frequency | 433 MHz |
| Radio Signal Range | 30 m typically (depends on the composition, density and number of walls) |
| Maximum Radiated Power | +7.5 dBm (5.6 mW) |
| Temperature Setting Range | 5°C to 30°C |
| Temperature Resolution | 0.5°C |
| Control Accuracy | ±0.5K at 20°C |
| Operating Ambient Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 55°C |
| Ambient Humidity (non-condensing) | Operating 25% to 90%, storage 15% to 95% |
| Protection Level | IP30 |
| Pollution Degree | 2 |
| Ball Pressure Test | 75°C |
| Software Class | A |
| Software Version | 6712058 |
| Energy Class | IV = 2% (according to EU 811/2013, 812/2013, 813/2013, 814/2013) |
| Thermostat Mounting | Surface or conduit box mounting, no wiring required |
| SCR Mounting | Industry standard wall plate, surface or flush single conduit box (M3.5 x 14 screws) |
| SCR Wallplate Minimum Clearances | 50 mm top, 40 mm each side, 70 mm bottom |
| Wiring | Fixed wiring only, compliant with IEE/IET wiring regulations (BS7671) |
| Mains Isolation | Double pole switch with at least 3 mm contact separation, fused at 3A |
| Electrical Insulation | Double insulated, no earth connection required |
| Dimensions (Thermostat) | 137 x 96.5 x 31.3 mm |
| Dimensions (SCR Receiver) | 98 x 88 x 37 mm |
| Controls | 4 buttons (On, Off, +, -) with digital display |
| Building Regulations | Part L compliant (Part J in Scotland) |
| Relevant Directives | 2014/53/EU RED, 2006/66/EC Batteries, 2011/65/EU RoHS |
| Applied Standards | EN60730-1, EN60730-2-9, EN 300 220-2, EN 301 489-3 |
Drayton Digistat 1RF Thermostat Details
The Drayton Digistat+1RF is a battery-powered wireless room thermostat. It sends its commands by radio to the SCR receiver, which is wired to the boiler or the central heating wiring centre. Because the thermostat itself needs no cables, there are no floorboards to lift, no plaster to chase out and no surface wiring. It can be placed anywhere within radio range instead of only where a cable can reach. Drayton also offers it as a clip-in control for Worcester Bosch boilers.
The display shows a sun icon in comfort (On) mode, a moon icon in setback (Off) mode and a flame icon when the thermostat is calling for heat. The Off button sets a reduced setback temperature, for example 15°C, and the On button returns to a comfort temperature, for example 22°C. This makes it quick to save energy when you go out shopping or for an evening. While you adjust a value, the setpoint is shown and then disappears after 5 seconds.
A user menu lets you change four values: maximum temperature (Hi), minimum temperature (Lo), the Off temperature and the On temperature. Press the On button to step through them and use + or - to change each one. If you reach a limit, the display flashes. To leave the menu, hold On and Off together for more than 5 seconds, or wait 1 minute. Setting the minimum and maximum to the same value makes the thermostat tamper-proof. You can also set a minimum temperature to protect vulnerable occupants.
An installer menu, shown as "Inst", covers Application Type (gas boiler, oil boiler or electric heat) and System Capability. Choose Fast if the house usually reaches the setpoint in under 1 hour, or Slow if it takes longer. To save a change, press On before you exit. To leave the installer menu, hold Off and + for more than 5 seconds, or wait 1 minute. The thermostat also has on/off load compensation for steadier temperature control.
Commissioning pairs the thermostat with its receiver. Put the SCR into learn mode by holding buttons 1 and 2 (Override) together. Hold the thermostat in sight of the SCR, at least one metre away, and fit the batteries. The red LED flashes for 7 seconds to confirm the link. Raise the setpoint until the flame appears and check that the boiler runs, then lower it again. In multi-zone homes, pair each thermostat and SCR one pair at a time.
A built-in signal strength test helps you choose where to mount the thermostat. Hold + while refitting the batteries and the display shows "rF" while the unit sends signals continuously. If the red LED on the SCR flashes continuously, the signal is good. Mount the thermostat on an inside wall about 1.5 m above the floor, away from direct sunlight, draughts, radiators, televisions and lamps. Mount the SCR at least 30 cm from metal objects and from the side panel of the boiler.
During normal use, the red LED on the SCR flashes for 7 seconds about every 5 minutes to confirm that a signal has been received. The green LED shows a call for heat. If the red LED stays on, no signal is getting through, often because the batteries are flat. The Override button lets you run the heating manually in that situation. A flashing battery icon warns that the batteries are low. When the battery icon is shown on its own, the batteries are exhausted and the thermostat has stopped working.
Frequently Asked Questions (FAQs)
Can't find the answer you need? Here are some frequently asked questions about the Drayton Digistat 1RF Thermostat, and we answer them below.
